I have sometimes used split rings to act as the eye for a bolt ring clasp and found that it is difficult to guide this thicker ring through the opening on the clasp. You may also find that closed rings or jump rings, because they are just a single layer of metal, work better with a clasp. If you are buying a ring to use as one half of a clasp (with a lobster or bolt clasp), then try to get a ring that is a similar size to the clasp (these are also available in a range of sizes usually) so that the components look as though they belong together. I have some rings in 10mm and these are useful for attaching to pendants as they are large enough to allow a clasp to pass through so that the pendant can be hung on a chain. I usually use rings that are around 5-7mm in size. If you’re buying online, make sure you check the size before you buy – it’s impossible to tell from the photo, so read the measurements. Much of this is a matter of preference and experience, so do not be afraid to experiment and try using different findings.Īll of these rings are available in a choice of metals and a variety of sizes. A split ring will solve this problem, but it may not look quite as elegant as the single closed ring. If I use a jump ring, there is a strong possibility that the very fine beading thread will slip through the gap in the metal, resulting in broken jewellery. If I am making something using bead-weaving techniques and stitching direct onto the ring, then I prefer to use a closed ring. I find that jump rings are ideal for attaching lightweight charms as they should not be under too much pressure when the jewellery is being worn. I prefer to use split rings when I am making jewellery with heavy beads or attaching clasps because there is no danger of these splitting apart when the jewellery is being used. If you are using a clasp, or another component, that has an opening, you can attach this to the closed ring. The same principle works whenever you are opening a ring on a clasp or earring finding – never pull it apart, but slide it back and forth.įinally, you can also buy ‘closed rings’ these are like split rings, but, as the name indicates, they have no opening, so you cannot use them to link components to one another in the same way.
The ring should then look as though it has never been opened and it will hold your component securely.
You can slip the ring onto your component and then carefully move the ends back together, again in a forward/backward alignment until they meet. If you look, the two ends have remained in the same alignment as they were when they were sealed. Instead, move the ends in a back and forth direction, so as you hold the ring as if you were looking through it, one end moves forwards towards you and the other end moves backwards away from you (see below). If you do, you will find that the metal circle is distorted out of shape and it is impossible to push the ends back together so as to re-shape the circle and make sure the ends meet properly. Never try to pull the two ends apart from one another in a sideways direction. Always use round nose pliers to open and close these rings. In both cases, there is a very important technique for opening the ring in order to be able to close it again after you have inserted your component.
0 kommentar(er)
